LED :: essays research papers

Q What is conduct (Light Emitting Diode)?A lead (Light Emitting Diode) is the most commonly used backlight for Cellular phones. The LED backlight offers well-nigh benefits over the EL backlight. To start, the LED backlight does not require an inverter, just a DC source of +3VDC+5VDC. Secondly, depending on the backlight configuration, the brightness can very bright, and thirdly, the vivification of the LED exceeds 50K hours.http//www.microtipsusa.com/content/Products_FAQS.asp17Abbreviation of light emitting junction rectifier, an electronic tress that lights up when electricity is passed through it. LEDs are usually red. They are dear for displaying images because they can be relatively small, and they do not burn out.http//www.webopedia.com/ term/L/LED.htmlhttp//www.edgesystem.net/LED_light_therapy.htmA small indicator light most oft used to show the power is on or the device is cosmos used. LEDs are found on your computer case, monitor, printer, modem, CD-ROM drive, and h ard drive.What is internal an LED?LEDs are special diodes that emit light when connected in a circuit. They are frequently used as "pilot" lights in electronic appliances to channelise whether the circuit is closed or not. A a clear (or often colored) epoxy case enclosed the heart of an LED, the semi-conductor chip. LED leads lieu lead on flatside of bulb = controvert      The two wires extending below the LED epoxy enclosure, or the "bulb" indicate how the LED should be connected into a circuit. The cast out side of an LED lead is indicated in two ways 1) by the flat side of the bulb, and 2) by the shorter of the two wires extending from the LED. The negative lead should be connected to the negative terminal of a battery. LEDs operate at relative low potentials surrounded by about 1 and 4 volts, and draw currents between about 10 and 40 milliamperes. Voltages and currents substantially above these values can melt a LED chip. The most importa nt part of a light emitting diode (LED) is the semi-conductor chip located in the center of the bulb as shown at the right. The chip has two realms separated by a junction. The p region is predominate by positive electric charges, and the n region is dominated by negative electric charges. The junction acts as a breastwork to the unravel of electrons between the p and the n regions. Only when sufficient voltage is applied to the semi-conductor chip, can the current flow, and the electrons cross the junction into the p region. In the absence of a large enough electric potential end (voltage) across the LED leads, the junction presents an electric potential barrier to the flow of electrons.